Cf_Progv Command; Cf_Nzred Command; Cf_Image Command - Sanyo PLC-XW250 - 2600 Lumens Manual

PLC-XW200/250 Expand Serial Command Functional Specifications
Acceptable
Response
Unacceptable
8.4.9

CF_PROGV Command

Command "CF_PROGV_%1"[CR]
"FILM" -------- Select Progressive Mode FILM
"L1" ----------- Select Progressive Mode L1
"L2" ----------- Select Progressive Mode L2
"OFF" --------- Cancel Progressive scan
%1
"UP" -----------Switch Progressive mode in positive order
"DN" -----------Switch Progressive mode in negative order
Set / cancel Progressive scan
Projector does not save the value set with this command so that it returns its
Details original when projector turning into Stanby mode or ALL is OFF. (The value is held
in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.4.10 CF_NZRED Command

Command "CF_NZRED_%1"[CR]
"OFF" ------- Cancel Noise Reduction
"L1" --------- Noise Reduction for moving image
"L2" --------- Noise Reduction for still image
%1 "UP" -----------Switch Progressive mode in positive order
"DN" -----------Switch Progressive mode in negative order
Noise Reduction based on frame correlation
Select L1 or L2 depending on motion detection
L2 is more effective in reducing noise than L1, however, L2 can have a blur in
moving image
Details
Projector does not save the value set with this command so that it returns its
original when projector turning into Stanby mode or ALL is OFF. (The value is held
in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.4.11 CF_IMAGE Command

Command "CF_IMAGE_%1"[CR]
"DYNAMIC" ------ Dynamic (Fixed value to enable projection with a sharp, powerful
"STAND" ---------- Standard (Image adjust value is set to factory default)
"REAL" ------------ Real (Fixed value to display graphic image with natural tone)
"CINEMA" -------- Cinema (Fixed value to focus on tone reproduction for movie)
"BLACKBOARD" – Blackboard (Fixed value to project image onto green-colored
%1
"COLORBOARD " – Colorboard(Fixed value to project image onto colored board)
"CUSTOM1" ----- Image1 (the value set and stored by a user)
"CUSTOM2" ----- Image2 (the value set and stored by a user)
"CUSTOM3" ----- Image3 (the value set and stored by a user)
"CUSTOM4" ----- Image4 (the value set and stored by a user)
"000"[CR]
"Error Code"[CR]
OFF → L1 → L2 → FILM → OFF
OFF → FILM → L2 → L1 → OFF
"000"[CR]
"Error Code"[CR]
OFF → L1 → L2 → FILM → OFF
OFF → FILM → L2 → L1 → OFF
"000"[CR]
"Error Code"[CR]
picture tone)
blackboard)
blackboard)
17 / 64