Pc Adjust Control Command; Cf_Fsync Command; Cf_Tdots Command; Cf_Clamp Command - Sanyo PLC-XW250 - 2600 Lumens Manual

PLC-XW200/250 Expand Serial Command Functional Specifications

8.5 PC Adjust Control Command

8.5.1

CF_FSYNC Command

Command "CF_FSYNC_%1"[CR]
"0000~0031" --------------- Directly select Fine Sync setting value
%1 "UP" -------------------------- Current Fine Sync setting value + 1
"DN" -------------------------- Current Fine Sync setting value - 1
Set Fine Sync value of PC signal
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.2

CF_TDOTS Command

Command "CF_TDOTS_%1"[CR]
"mmmm~nnnn" --- Directly select Total Dots setting value
"mmmm" shows minimum value, it is current Display Dots Horizontal value +
Position value
%1
"nnnn" shows maximum value, which is not over 140MHz.
"UP" -------------- Current Total Dots setting value + 1
"DN" -------------- Current Total Dots setting value - 1
Set Total Dots of PC signal
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.3

CF_CLAMP Command

Command "CF_CLAMP_%1"[CR]
"mmmm~nnnn" ---- Directly select Clamp setting value
"mmmm" shows minimum value, fixed-value "0001".
%1 "nnnn" shows maximum value: it depends on input signal.
"UP" ------------------ Current Clamp setting value + 1
"DN" ------------------ Current Clamp setting value – 1
Set Clamp value of PC signal
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.4 CF_H – POS Command
Command "CF_H-POS_%1"[CR]
"0000~nnnn" --- Directly select Horizontal Position setting value
"nnnn" shows maximum value, it is current Total Dots value - Display Dots value
%1
"UP" -------------- Current Horizontal Position setting value + 1
"DN" -------------- Current Horizontal Position setting value - 1
Set Horizontal Position value of PC signal.
Projector does not save the value set with this command so that it returns its
Details
original when projector turning into Stanby mode or ALL is OFF.
This command is available in normal Power ON status.
"000"[CR]
"101"[CR] --- when Input for Video is selected
.
"000"[CR]
"101"[CR] ---- when Input for Video is selected
"000"[CR]
"101"[CR] ---- when Input for Video is selected
19 / 64