Swap Drive; Re-Insertion Of Removable Drive - UniVision Canada PICO-2000 User Manual

Swap Drive

(Applicable to Archive
Backup mode of operation
only)
Re-insertion of
Removable Drive
TEC00-014
Make sure the system is properly setup with two available "Removable Hard
drive" and there is a fixed hard drive to support system operations.
Click the Swap Drive button in the Main Screen and then the "Swap drive"
message box will appear as shown in Figure 22.
Click the down arrow in the Select drive dialog box next to the Remove
button to display the registered removable drive(s) for removal and select the
desired drive. Click Remove button and follow the pop up instruction to
complete the REMOVE process.
The entire drive can be back up (Archive) to other long term storage media
such as the DAT or equivalent device with huge storage capacity but may not
work as fast. This operation on a dismounted drive can be down off-line
(while the PICO2000 is closed) or in a separate PC workstation.
Click the Swap Drive button in the Main Screen and then the "Swap drive"
message box will appear as shown in Figure 22.
Click the down arrow in the Select drive dialog box next to the Insert button
to display the registered removable drive(s) for insertion and select the desired
drive. Click Insert button and follow the pop up instruction to complete the
INSERTION (RE-Insertion) process.
If a blank new drive is inserted in the slot, make sure it is of the same make
and configuration as the removed drive for proper operation.
Figure 22
Pico2000 User Manual (Rev. 3.0) Page 39 of 51