Table of Contents
Advertisement
Backup function
Normal Mode
Archive Mode
Figure 20
Figure 21
Red – Indicate the Drive is set Active, being used for immediate video recording
Green – Indicates the Drive is dismounted, ready for physically taken out
TEC00-014
Make sure to select the intended Backup Mode prior the formal use of the
PICO2000 system for routine video recording.
Make sure to select the backup drive prior to the backup.
Click on Utility, then Option setting, and finally the Backup tab (Figure 20).
Click the down arrow in the backup drive box to display the available
removable drive(s) for backup and select the desired backup drive.
The removable device can be a DVD-RAM drive or a removable IDE hard
drive.
The user can choose to keep copies on hard disk after backup or not.
Click Apply to confirm and click OK to close the dialog box.
The system is set to "Normal" backup mode as system default. To switch to
"Archive" mode, check the bullet option next to Archive, then Apply and OK.
The PICO2000 application should closed and restarted to effect the change.
At the start up on Archive backup mode, the main screen of the PICO2000
will be slightly modified and refreshed as shown in figure 21.
Pico2000 User Manual (Rev. 3.0)
Swap
Drive
Page 38 of 51
Advertisement
Table of Contents
