Table of Contents
Advertisement
RECORDER SETTING
The recording
parameters
Frame rate
The start and end
times for scheduled
recording
TEC00-014
The instant recording, alarm recording and the scheduled recording modes
should have their individual sets of recording parameter settings.
Click the "Utility" button and then select the "Recording Setting" to start
program the recording parameters of individual cameras for different recording
modes.
Frame rate is the most important parameter for recording setting.
The value of frame rate is in f/s (frame per second), which controls how many
frames will be recorded for every second.
PICO-2000 provides a selection list for frame rate input. The possible frame
rates are 25, 12.5, 8, 4, 1, ½ and 1/60 frames per second respectively.
The ½ frame per second frame rate selection is interpreted as one frame
recorded every two seconds, and a 1/60 frames per second frame rate selection
means the recording of one frame every 60 seconds.
Note: The actual frame rate of recording will be same as this setting if the
system resource at the condition taken care of other system setting
permits. However, the PICO2000 may regard this setting as the target
maximum frame rate.
The start time and end time is needed for scheduled recording.
The input time is in the 24-hour HH:MM format.
The factory default setting of the weekday recording start time is 0:0 and the
default end time is also 0:0.
Under this default setting, the camera will start at Monday 0:0 and end at
Tuesday 0:0 and then start right away at Tuesday 0:0 and repeat all over again
for the rest of the weekdays. Therefore, weekday recording will record at all
times from Monday 0:0 through Saturday 0:0.
Weekend scheduled recording also has the default 0:0 start time and 0:0 end
time.
Under default start and end time the unit will start recording at Saturday 0:0
and end at Monday 0:0.
Pico2000 User Manual (Rev. 3.0)
Page 30 of 51
Advertisement
Table of Contents
