Table of Contents
Advertisement
Set detection area
Indicate the
detection area
Set sensitivity for
motion detection
Detection interval
Recording time
extension
Enable the motion
detection function
TEC00-014
The first thing to do is to input the detection area(s). Click the "Detection area
setup" button to show the grid on video screen for detection area selection.
Simply click on any spot to select/de-select the grid(s) to form detection area(s)
of any shape in the video screen for motion detection.
The "Select all" button is used to rapidly select the whole video screen for
detection.
The "Clear all" button is used to de-select all the selected areas.
If you want the detection area to be presented on the video screen during normal
operation, click the "Show at all time" button.
If you don't want the detection area to be presented in the video screen during
normal operation, click the "Not show" button.
Click the "Sensitivity setup" button to display the "activity blocks" for sensitivity
setup.
The "activity blocks" will superimpose on the moving object to highlight the
activities on the video screen.
You can adjust the sensitivity by using the sensitivity control box. Click the up
arrow button to increase the sensitivity and click the down arrow button to
decrease the detection sensitivity respectively.
The sensitivity value display inside the control box, which is an arbitrary value,
indicates the relative detection sensitivity.
Adjust the sensitivity by monitoring the "activity blocks" on the screen to
determine that the sensitivity is adjusted to an optimal condition for motion
detection and without false alarm.
User can check the "Show within detection area" button to confine the "activity
blocks" only to display within the detection areas you have selected.
The occurrence of motion is detected by correlating the successive frames of the
video. The "Detection interval" control box can adjust the detection interval
between these successive frames. The detection interval is in unit of 100mS.
The default value is at 200mS.
The motion detected in the detection area(s) will be used as an event to trigger
the alarm recording of the corresponding camera.
Once the recording is started, it will continue with an extension time even the
motion is stopped.
This extension time can be adjusted by using the "Post motion rec." control box.
The time interval is in unit of second show inside the control box and the default
value is 3 seconds.
Check the "Motion detection enable" box to enable the motion detection function
once you have set all the parameters.
(User can temporarily disable the motion detection by uncheck the "Motion
detection enable" box. All the settings of the motion detection will stay
unchanged, which let the user to enable the motion detection back again
afterward more easy).
Click the "Close" button, the corresponding camera button in the display panel
will light up with a yellow grid indicator to indicate the motion detection
function.
The detection area will be presented in the video screen if the "Show at all time"
button is checked.
Pico2000 User Manual (Rev. 3.0)
Page 24 of 51
Advertisement
Table of Contents
