Transducer adapter cables
For vessels with existing transducers that do not have the Navico blue 7 pin connector, there
are two adapter cables available to assist with installation.
For vessels that already have a transducer that was used with older Navico products that has 6
pin connector. Use 000-00022-001 6 pin to 7 pin transducer adapter cable.
These transducers will require the 10 k temp version of the transducer selected for transducer
type in Echo Installation. See the Echosounder Setup section on page 69 for further informa-
tion.
Blue 7 pin connector
6
5
1
7
2
4
3
Connector Pins
(Front View)
For other transducers that do not have Navico blue 7 Pin or 6 pin (above) connector that
require the connector to be removed. Use 000-10046-001 7 pin to bare wire adapter cable.
Not all transducers are compatible with NSS or BSM-1. Refer to the transducer type selection
list in the Echo Installation page to see if your transducer is mentioned for the selected echo
source. If not contact your Simrad dealer or Simrad Technical Support for assistance with
transducer compatibility. Simrad always recommends using Simrad transducers.
Blue 7 pin connector
6 pin connector
5
1
6
4
2
3
Connector Pins
(Front View)
Wire color
Connector Pin
7. Shield Temp -
4. Yellow Temp +
3. Orange Speed volts
2. Blue
6. Shield Depth Gnd.
5. Black
1. Red
6
5
1
7
2
4
3
Connector Pins
(Front View)
External GPS |
Function
Speed signal
Depth -
Depth +
| 23
NSS Installation Manual