Installation; Pre-Installation Guidelines; Installing The Enh202 - EnGenius ENH202 User Manual

2 Installation

This chapter describes how to install the ENH202.
Only experienced installation professionals who are familiar with local building and
safety codes and, wherever applicable, are licensed by the appropriate government regulatory
authorities should install the ENH202.

2.1 Pre-installation Guidelines

Select the optimal locations for the equipment using the following guidelines:
The ENH202 should be mounted on a 1"- 4" pole. Its location should enable easy access
-
to the unit and its connectors for installation and testing.
The higher the placement of the antenna, the better the achievable link quality.
-
The antenna should be installed to provide a direct or near line of sight link with the base
-
station antenna. The antenna should be aligned to face the general direction of the base
station.

2.2 Installing the ENH202

To install the ENH202, use the following procedure to mount the device on a pole and refer to
the figure below.
1. The bottom of the ENH202 is a removable cover. Grab the cover and push down
slightly while pulling it backward to remove the cover.
2. Insert a standard Ethernet cable into the RJ-45 port labeled MAIN LAN.
3. Slide the cover back to seal the bottom of the ENH202.
4. Remove the power cord and PoE injector from the box and plug the power cord
into the DC port of the PoE injector.
Only use the power adapter supplied with the ENH202. Using a different power
adapter might damage the ENH202.
5. Plug the other side of the Ethernet cable in Step 3 into the PoE port of the PoE
injector. When you finish Step 5, the installation will resemble the following picture.