EnGenius ENH202 User Manual page 59

Internet Connection
Type
MTU
IP Address
IP Subnet Mask
Gateway IP Address
PPTP Server
Username
Password
Connect on Demand
Keep Alive
Get Automatically
From ISP
Use These DNS Servers Select the Radio button for setup the Primary DNS and
Discard Ping on WAN
Accept / Cancel
Accept does not apply the changes – you must go to Status -> Save / Load
to apply the new settings. Please refer to Chapter 4.1 for more information.
If the router's MTU is set too high, downstream packets will be fragmented. If
the router's MTU is set too low, the router will fragment packets unnecessarily and, in extreme
cases, may be unable to establish connections. In either case, network performance can suffer.
Select PPTP to begin configuration of the PPTP connection.
Specify the Maximum Transmit Unit size. EnGenius recommends
that it remains in Auto.
Specify WAN port IP address.
Specify WAN IP Subnet Mask.
Specify WAN Gateway IP address.
Specify PPTP Server IP address.
Specify the Username that is given by your ISP.
Specify the Password that is given by your ISP.
Select the Radio button to specify the maximum idle time. The
Internet will disconnect when it reaches the maximum idle time;
however, it will automatically connect when a client tries to access
the network.
Select the Radio button to keep internet connection always on.
Specify the redial period once the internet lose connection.
Select the Radio button for the DNS servers to be obtained
automatically from the DHCP server.
Secondary DNS servers manually.
Place a check to Enable or Disable ping from WAN.
Press Accept to confirm the changes or Cancel to return
previous settings.