D-Link SharePort DIR-506L User Manual page 31

Section 3 - Configuration
If you selected PPPoE, you will see the following settings. Your ISP will provide you with a username and password. This option
is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer
needed and will not work through a router.
Address Mode: Select Static IP if your ISP assigned you an IP address,
subnet mask, gateway and DNS server address. In most
cases, select Dynamic IP.
IP Address:
Enter the IP address (for static PPPoE only).
Username:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password
in the next box.
Service Name: Enter the ISP service name (optional).
Reconnect
Mode: Select either Always-on, On-Demand, or Manual.
Maximum Idle Enter a maximum idle time during which the Internet
Time: connection is maintained during inactivity. To disable this
feature, set the Reconnect Mode to Always on.
Primary/
Secondary DNS Enter the primary and secondary DNS server addresses
Server: (Static PPPoE only).
MTU: If you experience connection issues, you may need to
change the MTU setting for optimal performance with
your specific ISP. 1492 is the default MTU.
MAC Address: If your ISP requires you to enter a MAC address, enter it
here. You can click the Clone Your Pc's MAC Address
button to copy your current computer's MAC address.
D-Link DIR-506L User Manual 27