Section 2 - Installation
1. Make sure the battery is installed properly (see page 7). Connect the USB cable to the DIR-506L and then connect to a USB
port on your computer. It is strongly recommended to charge the battery at least four hours before using.
2. Push the power button to the on position and wait until the power
LED turns green.
3. By default the DIR-506L is in Router mode and must be connected
wirelessly with a computer or mobile device to set up.
4. Using a wireless computer or mobile device, launch your wireless
utility and connect to the DIR-506L. The default Wi-Fi Network
Name (SSID) is dlink_DIR-506L and the Wi-Fi Password is left blank
(no security).
D-Link DIR-506L User Manual
Installation
First Time Setup
-
+
LAN
LAN
ON
OFF
ON
5V
OFF
5V
SharePort
13