Power Up the Disk Array
Lift the power/standby switch door up, then press the power/standby switch to the power on (in) position.
Wait for the control panel to display "Ready", indicating that the disk array has successfully completed
its initialization and is ready for use.
Configure the Disk Array Using the Control Panel
Several disk array operating settings must be configured before the disk array will operate properly in the
Windows NT cluster environment. These settings are changed using the control panel located on the front of the
1 – Available Choice
2 – Selection History
3 – Scroll Text Left
4 – Cancel Selection
5 – Display Main Menu
6 – Scroll Menus/Items
If the controller batteries are fully discharged, it may take up seven minutes for the disk
array to display "READY" status.
Figure 8. Control Panel Display and Function Keys
7 – Select Menu/Items
8 – Scroll Text Right
9 – Control Panel Status Light
10 – Controller Indicator (x or y)
11 – Menu/Item Scroll Indicator