To Install The Ups Software On The Hp Netserver - HP D5970A - NetServer - LCII User Manual

Chapter 4

To Install the UPS Software on the HP NetServer

NOTE
You must have administrator capabilities to install
this software.
Install the HP PowerWise Assistant application on the HP NetServer to which the
UPS is connected and on a local Windows client used to manage the server. With
Novell NetWare, you can have more than one server connected to a UPS. The
server to which the UPS is connected via the serial cable is the "Master" server.
Other servers powered by the UPS are "Slave" servers.
To install the UPS Software, follow these steps:
1. Insert the HP NetServer Navigator CD-ROM into the CD-ROM drive that
is accessible from the Windows client.
2. In the Windows Program Manager, select Run from the File drop-
down menu.
3. At the Command Line prompt, type the following:
{drive}:\PWA\NETWARE\DISK1\SETUP.EXE
where {drive} is the letter of the CD-ROM drive.
4. Follow the instructions on the screen.
You will be prompted to identify an installation path for the software.
In the Installation Options window, select PowerWise Assistant.
You will need to identify the server as a Master or a Slave. For the
Master server, you must identify the port on the server to which the HP
PowerWise UPS is connected. For a Slave server, you must provide
the name of the Master.
5. Depending on your installation choices, one or more of the following
commands are added to the AUTOEXEC.NCF file:
load aiocomx
load hpups
load hpslave
load hpupscag
load hpupssd
Either reboot the server to load these files, or manually load them by
entering pwaload at the server console.
Installing UPS Software
23