Specifying Device Settings; Fingerprints; Smart Card; Face - HP ProBook 4325s - Notebook PC User Manual

Specifying device settings

Within the Device application, you can specify settings available for any built-in or attached security
devices recognized by HP ProtectTools Security Manager.

Fingerprints

The Fingerprints page has three tabs: Enrollment, Sensitivity, and Advanced.
Enrollment
You can choose the minimum and maximum number of fingerprints that a user is allowed to enroll.
You can also clear all of the data from the fingerprint reader.
CAUTION:
including administrators. If the logon policy requires fingerprints only, all users may be prevented from
logging on to the computer.
Sensitivity
To adjust the sensitivity used by the fingerprint reader when it scans your fingerprints, move the slider.
If your fingerprint is not recognized consistently, a lower sensitivity setting may be necessary. A higher
setting increases the sensitivity to variations in fingerprint scans and therefore decreases the possibility
of a false acceptance. The Medium-High setting provides a good mix of security and convenience.
Advanced
You can configure the fingerprint reader to conserve power when the computer is running on battery
power.

Smart card

You can configure the computer to automatically lock when a smart card is removed. However, the
computer will lock only if the smart card was used as an authentication credential when logging on to
Windows. Removing a smart card that was not used to log on to Windows will not lock the computer.
Select the check box to enable or disable locking the computer when the smart card is removed.
▲

Face

You can set the security level for Face Recognition to balance the ease of use and the difficulty of
breaching the security of the computer.
1. Click Start, click All Programs, click HP, and then click HP ProtectTools Administrative
Console.
2. Click Devices, and then click Face.
16 Chapter 4 Configuring your system
Clearing all of the data from the fingerprint reader erases all fingerprint data for all users,