Step 1-Preparing For Component Installation; Accessing The Internal Components Of The Computer; Removing Components - HP Z600 - Workstation - 6 GB RAM Installation Manual

Step 1—Preparing for component installation
NOTE: Computer models vary. All illustrations are examples only.

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and replacement
procedures in the service guide for your computer at http://www.hp.com/support/manuals.
2. Power down the computer, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the computer.
4. Remove the side access panel.

Removing components

1. If present, remove the card support to enable access to the expansion slots and system board
connectors.
2. Select an appropriate PCIe expansion slot and remove the slot cover. The Sound Blaster card can
be installed in any PCIe expansion slot.
NOTE:
panel.
Figure 1
ENWW
To identify an available PCIe expansion slot, see the service label on the side access
Removing the expansion slot cover
Step 1—Preparing for component installation 3