HP Z600 - Workstation - 6 GB RAM Installation Manual page 4

Step 2—Installing the Sound Blaster audio card
1. Install the Sound Blaster audio card (1) in the selected PCIe expansion slot, and then secure the
expansion slot retention clamp (2).
Figure 2
2. Disconnect the front audio cable from the front audio header on the system board.
NOTE:
3. Connect the front audio cable from the system board to the front audio connector (1) on the Sound
Blaster audio card.
NOTE:
the add-in audio card. In this case, use the audio connections on the card. The HP Z Workstation
series is fully compatible.
Figure 3
4 PCI Express Sound Blaster X-Fi Titanium audio card installation
Installing the audio card
To locate system board components, see the service label on the side access panel.
The existing internal front audio cable in certain workstations may be incompatible with
PCIe Sound Blaster X-Fi Titanium audio card
ENWW