Installing The Media Card Reader - HP Z400 - Workstation Installation Manual

Installing the media card reader

Installing the 5.25-inch bay adapter
To install the 3.5-inch media card reader into a 5.25-inch drive bay, you must first install the reader
into the 5.25-inch bay adapter.
1. If installing the media reader in an HP Z200 or Z400 Workstation, install four black M3 guide
screws in the four lower holes of the bay adapter.
Figure 1
2. To install the media reader in the 5.25-inch optical bay adapter:
a. Leave the four preinstalled guide screws in the lower holes of the media reader (1) in place.
b. Use the four guide screws to align the media reader with the adapter (1).
c. Lower the media reader into the adapter (2).
Figure 2
d. Align the rear screws on the drive with the channel in the carrier (3).
e. To fully seat the media reader in the carrier, the carrier cannot be in contact with a solid
surface. Lift the carrier up as you slide the drive forward (4).
ENWW
Installing the guide screws in the bay adapter for HP Z200 and Z400 Workstations
Installing the media reader in the bay adapter
Installing the media card reader 3