HP Z210 Series User Manual page 65

6.
Rotate the drive cage to its upright position.
Figure 10-8
7.
If a cable is not already present and connected, connect the SATA data cable to the system board
connector labeled SATA1.
Route the data cable through the cable guides. Two cable guides keep the data cable from being
pinched by the drive cage when raising or lowering it. One is located on the bottom side of the
drive cage. The other is part of the chassis frame under the drive cage. Ensure that the data cable
is routed through these guides before connecting it to the optical drive.
Figure 10-9
ENWW
Rotating the Drive Cage Up
Routing the drive cable
Installing an optical drive in an HP Z210 SFF Workstation
57