Diagnostic Lights And Audible (Beep) Codes - HP Xw4550 - Workstation - 2 GB RAM Troubleshooting Manual

Table 5-2
Problem
A new device is not
recognized as part of
the system.
Workstation will not start.
Workstation will not shut
down.

Diagnostic lights and audible (beep) codes

This section describes the front panel light (LED) error and operation codes as well as the audible codes
that might occur before or during the POST.
42 Chapter 5 Troubleshooting
Hardware installation problems
Probable Cause
Device is not seated or
connected properly.
Cables of new external
device are loose or power
cables are unplugged.
Power switch of new
external device is not turned
on.
When the system advised
you of changes to the
configuration, you did not
accept them.
A plug and play board might
not automatically configure
when added if the default
configuration conflicts with
other devices.
Wrong memory modules
were used in the upgrade or
memory modules were
installed in the wrong
location.
Proper steps were not
followed.
Recommended Solution
Ensure that the device is properly and securely connected and that pins
in the connector are not bent down.
Turn off the workstation, turn on the external device, then turn on the
workstation to integrate the device with the workstation system.
Reboot the workstation, and follow the instructions for accepting the
changes.
Use Computer Setup (F10) to reconfigure or disable devices to resolve
the resource conflict.
1. Review the documentation that came with the system to determine
if you are using the correct memory modules and to verify the proper
installation.
2. If you still cannot resolve the issue, contact Customer Support.
3. Observe the beeps and LED lights on the front of the workstation.
See Diagnostic lights and audible (beep) codes on page 42
determine possible causes.
1. Shut down the operating system software.
2. Manually turn off power to the workstation by pressing and holding
the power button for four seconds.
CAUTION: Manually turning off the power bypasses the standby
state and can result in loss of data.
3. To reconfigure the power button to work in On/Off mode, run
Computer Setup (F10).
For more information about using Computer Setup, refer to the Service
and Technical Reference Guide, which is available through a link on
the Documentation and Diagnostics CD
workstation_manuals).
to
(http://www.hp.com/support/
ENWW