Viewing Your Workstation Configuration - HP Workstation x1100 Getting Started Manual

viewing your workstation configuration
The Summary Screen gives you a summary of the current configuration
of your workstation (for example: BIOS version, CPU speed, memory
module size, and installed mass storage devices).
You should check the configuration of your workstation when you first
use it and each time after you install, remove, or upgrade accessories. To
check the configuration:
1. Turn on the display and then the workstation. If the workstation is
already turned on, save your data and exit all programs, then restart
the workstation. Consult your operating system documentation for
any special instructions concerning turning off and restarting your
workstation.
2. Press when the start-up logo appears on your display. This takes
Esc
you to the Summary Screen. (To go immediately into the Setup
program, and bypass the Summary Screen, press
The Summary Screen is displayed for only a short time. Press the
Pause/Break key on the keyboard to retain the Summary Screen
until another key is pressed.
Chapter 1
setting up and using your workstation
viewing your workstation configuration
instead of
F2
).
Esc
31