HP Workstation x1000 Installation Manual page 35

HP Visualize fx2+, fx4+, fx6+ Graphics Cards and Texture Module
Solution
If the texture module is not
installed, check that a
terminator is present and firmly
connected.
Run the diagnostics tool.
Check that you are using the
correct video driver. The video
driver version is displayed in
the About panel.
Chapter 1
Installing the HP Visualize fx+ Graphics Card
Explanation
The figure below shows the
location of the terminator. To
check if the terminator is firmly
connected, you may need to
remove the card's strengthening
bar and then replace it. (You
can use a Torx screwdriver or
a flat-blade screwdriver of the
correct size.)
For more information on the
diagnostics tool, see the section
"Diagnostics Tool."
you may have updated the HP
V fx+ driver with the
ISUALIZE
wrong version. The fx+ (fx4+
and fx6+) drivers use the form
FX.00.02.xx and the fx4
driver uses the form
FX.00.00.xx.
35