HP Visualize fx2+, fx4+, fx6+ Graphics Cards and Texture Module
Installing the HP Visualize fx+ Graphics Card
2. Slide the left-side panel toward the rear of the Personal Workstation
Figure 1-2
Sliding the Left-Side Panel to the Rear of the Personal
Workstation
3. Remove the left-side panel by grasping the rear part of the panel as
Figure 1-3
Removing the Left-Side Panel
16
approximately 0.5 inches as shown in Figure 1-2.
shown in Figure 1-3 and pulling the panel outward. Next, lift the
panel up and away from the Personal Workstation, and place it where
its exterior surface cannot be damaged.
This gap is approximately
0.5 inches.
Chapter 1