Remote Sensor Is Not Receiving A Signal From The Remote Control; Memory Card Reader - HP s7600n - Pavilion Media Center Getting Started Manual

70
HP Media Center PC Getting Started Guide

Remote sensor is not receiving a signal from the remote control

If a faint red light doesn't appear when you point
the remote control at the remote sensor and press
the OK button, try the following:
1
Click Start, right-click My Computer, and
then select Properties.
2
Click the Hardware tab, and then click
Device Manager.
3
Click the plus (+) sign next to Universal Serial
Bus Controllers.
4
If the eHome Infrared Receiver is listed under
Universal Serial Bus Controllers, Windows is
properly detecting the IR Receiver. If it is not
listed, go to the next step.

Memory Card Reader

Digital cameras and other digital imaging devices
use memory cards, or media, to store digital picture
files. The optional memory card reader can read
and can write to a variety of types of memory cards
and the Microdrive disk drives.
The card reader is accessible directly on the front of
the PC. It has four horizontal card slots, which
accept the memory cards and the Microdrive disk
drive.
5
Unplug the end of the USB cable on the
remote sensor from the PC, and plug it into the
same USB port.
6
Disconnect all other USB devices, leave the
remote sensor plugged in, and then restart the
PC. Plug in other USB devices after the remote
sensor appears in the Device Manager
window.
You can place media in one or more of the card
slots and use each media independently. Place only
one piece of media in a slot at one time. Each card
slot has its own drive letter and icon. When you
insert media, the display label may change to the
title of the media, if the title is present.