Public Networks - HP Rx2620-2 - Integrity - 0 MB RAM Installation And Configuration Manual

4. Click the General tab. Be sure that only the Internet Protocol (TCP/IP) checkbox is selected.
5. If you have a network adapter that transmits at multiple speeds, manually specify a speed
and duplex mode. Do not use an autoselect setting for speed, because some adapters can
drop packets while determining the speed. The speed for the network adapters must be
hard set to the same speed on all nodes according to the card manufacturer specification.
If you are not sure of the supported speed of your card and connecting devices, Microsoft
recommends setting all devices on that path to 10 MB per second and Half Duplex.
NOTE:
identically to use the same Duplex Mode, Link Speed, Flow Control, and so on. Contact
your adapter manufacturer for specific information about appropriate speed and duplex
settings for your network adapters.
6. Click the Internet Protocol (TCP/IP), then click Properties.
7. Click the General tab, verify that you have selected a static IP address that is not on the
same subnet or network as any other public network adapter.
For example, use 10.10.10.10 for the private adapters on node 1 and 10.10.10.11 on node 2
with a subnet mask of 255.0.0.0. Be sure to use a different IP address scheme than that used
for the public network.
8. Verify that no values are defined in the Default Gateway or Use the following DNS server
addresses fields, and click Advanced.
9. Click the DNS tab and verify that no values are defined in this field. Be sure that the Register
this connection s address in DNS and the Use this connection s DNS suffix in DNS
registration checkboxes are cleared.
10. Click the WINS tab and verify that no values are defined in this field. Click Disable NetBIOS
over TCP/IP.
11. Close the dialog box, and click Yes if the following message appears:
This connection has an empty primary WINS address. Do you want to continue?
12. Repeat Step 1
IP addresses.

Public Networks

To configure your public networks, complete the following steps:
1. Right-click the My Network Places icon on your desktop, and select Properties.
2. Determine which Local Area Connection icon in the Network Connections window
represents your public network. Right-click that icon, select Rename, and change the name
to Public. If you have more than one public network (recommended), you can name them
Public-1, Public-2, and so on. Repeat for each of your public network connection icons.
3. Right-click the Public icon and select Properties.
4. Click the General tab, click Internet Protocol (TCP/IP), then click Properties.
5. Click the General tab, and assign the IP Address and Subnet Mask values determined by
your network administrator.
6. Click OK several times to implement the changes and exit the connection properties window.
7. Click Start Settings Control Panel and double-click Network Connections. In the
Network Connections Advanced menu, select Advanced Settings. In the Connections box,
verify that your connections are listed in the following order:
1. External public network
2. Internal private network and heartbeat
3. Remote access connections
26 Administering the cluster
All network adapters in a cluster attached to the same network must be configured
through Step 11 for all remaining nodes in the cluster, using different static