Configuring Private And Public Network Role And Priority Settings - HP Rx2620-2 - Integrity - 0 MB RAM Installation And Configuration Manual

4. In the Action menu list, select Add Nodes to Cluster and click OK.
5. In the Welcome to Add Nodes wizard, click Next.
6. Enter the name of the node you want to add under Computer Name, click Add, then click
Next. Cluster analysis begins.
NOTE:
clicking Add. This adds all nodes to the cluster in a single step. However, there is a risk with
this method. If there is any kind of problem during the add process that causes it to abort,
it is much more difficult to determine which node caused the problem. For this reason, HP
recommends that you add the nodes one at a time.
7. The blue Tasks Completed bar grows longer during this process. The bar stays blue up until
it fills completely, then it turns green. Click Next.
NOTE:
occurred and cluster analysis was aborted. See the log file to locate the source of the problem.
Debug or reconfigure as necessary and try again.
8. Enter the Password for the cluster service account and click Next.
9. A detailed summary of the proposed cluster displays. Review this information, then click
Next to begin the node addition process.
10. The blue Tasks Completed bar grows longer during this process. The bar stays blue up until
it fills completely, then it turns green. Click Next.
NOTE:
occurred and cluster analysis was aborted. See the log file to locate the source of the problem.
Debug or reconfigure as necessary and try again.
11. When the wizard finishes adding the node, click Next, then click Finish.
12. Repeat Step 1

Configuring Private and Public Network Role and Priority Settings

To configure the private and public network role settings, complete the following steps:
1. Select Start Programs Administrative Tools Cluster Administrator.
2. In the left pane under Cluster Configuration Networks, right-click Private and select
Properties.
3. Click the General tab, and click Internal Cluster Communications only (private network).
Click Apply OK.
4. In the same network folder (Cluster Configuration Networks), right-click Public and
select Properties.
5. Click the General tab, and click All communications (mixed network). Click Apply OK
to apply the changes.
To configure the network Priority settings, complete the following steps:
1. Select Start Programs Administrative Tools Cluster Administrator.
2. In the left pane, right-click the cluster name and select Properties.
3. In the Network Priority tab, locate the Networks used list. Be sure the line labeled Private
is at the top of this list, above the line labeled Public. If you need to change the order, select
Private and click Move Up to move it upward. Click Apply OK to apply the changes.
30 Administering the cluster
You can list all the nodes at the same time by entering the name of each one and
If the Tasks Completed bar turns red at any time during this process, an error
If the Tasks Completed bar turns red at any time during this process, an error
through Step 11 for each node you want to add to the cluster.