Uninstalling The Smart Array Multipath Software Driver; Installation For An Existing 2-Node Cluster With Microsoft Windows 2000 - HP StorageWorks 500 - G2 Modular Smart Array User Manual

Uninstalling the Smart Array Multipath software driver

CAUTION: Before uninstalling the software driver in a Microsoft® Windows® Server 2003 clustering
environment, use the Cluster Administrator to stop the cluster service on the appropriate node.
Power down the server.
1.
Disconnect all SCSI cables from any controller in the storage system, unless the boot drive is
2.
attached.
Power up the server.
3.
Select Start>Settings>Control Panel.
4.
Select Add/Remove Programs.
5.
From the list of components, select HP Smart Array Multipath Software 2.0C.
6.
NOTE: For Microsoft® Windows® Server 2003 only, the selection is HP Smart Array Multipath Driver.
Click Change/Remove.
7.
Click OK.
8.
NOTE: A Microsoft® Windows® Server 2003 system does not indicate progress during the removal. Wait
at least 10 minutes to allow the system to complete the removal.
Click Cancel.
9.
Shut down the server.
10.
Disconnect the SCSI cable from the redundant HBA.
11.
Installation for an existing 2-node cluster with Microsoft
Windows 2000
Log on to one node of the cluster with an account having domain administrator privileges.
1.
Open the Cluster Administrator and move all cluster groups to the second node.
2.
On the first node, stop the cluster service and set the startup type to Manual.
3.
Install the HP Smart Array Multipath Software. Refer to "Multipath installation for Microsoft (on page
4.
11)."
Reboot as instructed.
5.
Log on to Windows® 2000 with an account having domain administrator privileges.
6.
Click Yes or OK for any new hardware found or installed.
7.
Shut down the system. Do not reboot.
8.
Install the second HBA and connect the cable from second HBA to the storage system.
9.
Power up the server.
10.
Log in to Windows® 2000 with an account having domain administrator privileges after the startup
11.
completes.
Start the cluster service and set the startup type to Automatic.
12.
Open the Cluster Administrator.
13.
Move the disk groups from the second node to the first node and verify that all groups come online.
14.
Repeat all steps for the second node.
15.
Installation and operation in Microsoft environments 10