Safety Information - IBM NetVista Hardware Maintenance Manual

Safety Information

DANGER
To avoid a shock hazard, do not connect or disconnect any cables or perform installation, maintenance, or
reconfiguration of this product during an electrical storm.
To avoid shock hazard:
The power cord must be connected to a properly wired and grounded receptacle.
Any equipment to which this product will be attached must also be connected to properly wired receptacles.
When possible, use one hand to connect or disconnect signal cables to prevent a possible shock from touching
two surfaces with different electrical potentials.
Electrical current from power, telephone, and communications cables is hazardous. To avoid shock hazard,
connect and disconnect cables as described following when installing, moving, or opening covers of this product
or attached devices.
To Connect
1. Turn Everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to receptacles.
4. Attach power cord(s) to outlet.
5. Turn device ON
6
To Disconnect
1. Turn Everything OFF.
2. First, remove power cord(s) from outlet
3. Remove signal cables from receptacles.
4. Remove all cables from devices.