IBM NetVista Hardware Maintenance Manual page 77

Table 2-1 POST Error Codes and Messages List
NOTE:
To diagnose a problem, first find the BIOS error
messages or codes in left column. If directed to a
check procedure, replace the FRU indicated in the
check procedure. If no check procedure is indicated,
the first Action/FRU listed in right column is the most
likely cause.
BIOS Error Codes,
Messages
Floppy Disk(s) Fail (80)
Floppy Disk(s) Fail (40)
Hard Disk(s) Fail (80)
Hard Disk(s) Fail (40)
Hard Disk(s) Fail (20)
Hard Disk(s) Fail (10)
Hard Disk(s) Fail (08)
Action/FRU
1. Re-connect floppy disk
drive
2. Enter Configuration/
Setup Utility and load the
default settings.
3. Floppy disk drive
4. System board
1. Re-connect floppy disk
drive
2. Enter Configuration/
Setup Utility and load the
default settings.
3. Floppy disk drive
1. Enter Configuration/
Setup Utility and load the
default setting
2. Check IDE drive jumper.
See "3.5-In. Hard Disk
Drive Jumper Settings"
on page 117.
3. IDE hard disk drive
power.
4. IDE hard disk drive cable/
connection.
5. IDE hard disk drive.
6. System board
1. Enter Configuration/
Setup Utility and load the
default setting
2. IDE hard disk drive
power.
3. IDE hard disk drive cable/
connection.
4. IDE hard disk drive.
1. Hard disk drive
Check Procedures 43