IBM NetVista Hardware Maintenance Manual page 75

Table 2-1 POST Error Codes and Messages List
NOTE:
To diagnose a problem, first find the BIOS error
messages or codes in left column. If directed to a
check procedure, replace the FRU indicated in the
check procedure. If no check procedure is indicated,
the first Action/FRU listed in right column is the most
likely cause.
BIOS Error Codes,
Messages
Error Encountered
Initializing Hard Drive
Error Initializing Hard Disk
Controller
Floppy Disk CNTRLR Error
Or No CNTRLR Present
Invalid EISA Configuration
Please Run EISA
Configuration Utility
Keyboard Error or No
Keyboard Present
Action/FRU
1. Enter Configuration/
Setup Utility to load the
default setting
2. IDE hard disk drive power
3. IDE hard disk drive cable/
connection
4. IDE hard disk drive
1. Enter Configuration/
Setup Utility to load the
default setting
2. Check IDE drive jumper
See "3.5-In. Hard Disk
Drive Jumper Settings"
on page 117.
3. IDE hard disk drive power
4. IDE hard disk drive cable/
connection
5. IDE hard disk drive
6. System board
1. Enter Configuration/
Setup Utility to load the
default setting
2. Diskette drive cable/
connection
3. Diskette drive
4. System board
1. No ESIA slot available
1. Re-connect keyboard
2. Enter Configuration/
Setup Utility and load the
default settings
3. keyboard
4. System board
Check Procedures 41