Important Safety Information - HP Brio ba600 User Manual

Important Safety Information

For your safety, never remove the PC's cover without first removing the power cord and any
connection to a telecommunications network. Always replace the cover before switching the
PC on again.
For your safety, always connect equipment to a grounded electrical wall outlet. Always use a
power cord with a properly grounded plug, such as the one provided with the equipment, or
one in compliance with your national safety standards. The equipment can be disconnected
from the power by removing the power cord from the power outlet. This means the equipment
must be located close to an easily accessible electrical outlet.
To avoid electrical shock, do not open the power supply. There are no user-serviceable parts
inside.
There is a danger of explosion if the battery is incorrectly installed. For your safety, never
attempt to recharge, disassemble or burn an old battery. Only replace the battery with the
same or equivalent type, as recommended by the manufacturer. The battery in this PC is a
lithium battery that does not contain any heavy metals. Nevertheless, in order to protect the
environment, do not dispose of batteries in household waste. Please return used batteries
either to the shop from which you bought them, or to the dealer from whom you purchased
your PC, or to HP, so that they can either be recycled or disposed of in the correct way.
Returned used batteries will be accepted free of charge.
Do not attempt to connect this product to the phone line during a lightning storm. Never
install telephone jacks in wet locations unless the telephone line has been disconnected at the
network interface. Never touch uninsulated telephone wires or terminals unless the telephone
line has been disconnected at the network interface. Use caution when installing or modifying
telephone lines. Avoid using a telephone (other than a cordless type) during a lightning storm.
There may be a risk from lightning. Do not use the telephone to report a gas leak in the vicinity
of the leak. Never touch or remove the communications board without first removing the
connection to the telephone network.
ii