HP BL685c - ProLiant - 4 GB RAM User Manual page 27

CAUTION: To avoid damage to the system board:
Do not touch the processor socket contacts.
Always install the processor socket cover after removing the processor from the socket.
Do not tilt or slide the processor when lowering the processor into the socket.
CAUTION: To avoid damage to the processor:
Handle the processor only by the edges.
Do not touch the bottom of the processor, especially the contact area.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
CAUTION: The server blade supports only two- or four-processor configurations. Always
populate processor sockets 1 and 2 with processors and heatsinks. To prevent overheating,
always populate processor sockets 3 and 4 with processors and heatsinks or processor socket
covers and heatsink blanks.
CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the
heatsink is removed from the processor after it has been installed.
IMPORTANT:
is empty, the server blade does not power up.
To install a processor:
Power down the server blade (on page 14).
1.
Remove the server blade (on page 15).
2.
Remove the access panel (on page 15).
3.
Remove the heatsink blank. Retain the heatsink blank for future use.
4.
Processor sockets 1 and 2 must always be populated. If either processor socket
Hardware options installation 27