Advertisement
6
To disable enhanced fragmentation for IP NAT, use the command
DISABLE IP NAT FRAGMENT={ICMP|UDP|OTHER}
To configure the number of fragments permitted per packet for Firewall, use
the command:
SET FIREWALL FRAGMENT=8...50
To configure the number of fragments permitted per packet for IP NAT, use
the command:
SET IP NAT FRAGMENT=8...50
TCP has been excluded from this enhancement because TCP has the MSS
(Maximum Segment Size) parameter for segment size control. Also, for
PPPoE interfaces with a reduced MTU of 1492, a previous enhancement in
PCR 02097 ensures that TCP MSS values in sessions carried by a PPPoE
interface are clamped to a value that prevents fragmentation.
PCR 02116
Module: IPG PING
When pinging to a remote IP address with two or more different cost routes,
if the preferred route became unavailable, the ping failed to switch to the
less preferred route until the ping was stopped and restarted. This issue has
been resolved.
PCR: 02371
Module: FIREWALL
When the system time was set to a time that was before or significantly after
the current time, Firewall sessions were prematurely deleted. This issue has
been resolved.
PCR: 03011
Module: OSPF
When the router priority was changed on a dynamic OSPF interface, the
new priority did not appear in the output of the SHOW OSPF NEIGHBOUR
command on neighbouring routers. The new priority only showed after the
RESET OSPF command was executed on the neighbouring routers. This
issue has been resolved.
PCR: 03026
Module: IPG
After setting the IGMP query timer with the SET IP IGMP command, and
saving the configuration, the IGMP Other Querier timeout was not set to the
correct value after a restart. This issue has been resolved.
PCR: 03027
Module: DHCP
Entries in the process of being reclaimed as static entries (and waiting for
the remote IP to become routable), were disrupting the reclaim process. This
prevented further entries from being reclaimed. DHCP static entries are
now fully subject to normal reclaim processing.
PCR: 03032
Module: SWI
If the ENABLE IP IGMP command was executed before the ENABLE
SWITCH L3FILTER command, Layer 3 filtering did not discard packets
destined for the CPU. This issue has been resolved.
PCR: 03035
Module: OSPF
Link state advertisements could incorrectly show an area as a stub area. This
happened during the time when a Direct Route (DR) was removed from a
configuration and before a Direct Backup Route (BDR), or an Other Direct
Route (Other DR) was elected. This issue has been resolved.
Patch Release Note
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Patch 86222-25 for Software Release 2.2.2
C613-10319-00 REV X
Advertisement
