Advertisement
30
PCR: 01206
Module: ISAKMP
A memory loss occurred when certificates were used by ISAKMP. This issue
has been resolved.
PCR: 01207
Module: ISAKMP
ISAKMP heartbeats are no longer transmitted if the lower layer interface is
down. This stops ISAKMP heartbeats from bringing up links in dial-up
environments.
PCR: 01209
Module: ISAKMP
In some conditions it was possible for ISAKMP packets to be lost and not
retransmitted. Incoming ISAKMP messages are now validated before
stopping retransmission of the previous message.
PCR: 01211
Module: SWI
The COS_DST bit on ARL for L3 interface should be 0x4 (higher priority) for
CPU ports. This has been corrected.
PCR: 01213
Module: TRG, SNMP
The Trigger Facility was generating a trap with variable { 0 0 }, and was not
documented in the ATI enterprise MIB. This issue has been resolved. The
MIB object triggerLastTriggerActivated ({ enterprises(1) alliedTelesyn(207)
mibObjects(8) brouterMib(4) atrouter(4) modules(4) trigger(53) 1 }) has been
defined, to record the trigger number of the last trigger activated, and this
variable is now transmitted in the trigger activation trap triggerTrap.
PCR: 01214
Module: SWI
In a Rapier G6, fitted with a fibre uplink module with all ports active,
switching traffic between port 1 and the uplink caused the traffic flow to
cease after a period of time depending on the volume of traffic. This issue
has been resolved.
PCR: 01216
Module: STP
The Rapier did not include the message age of the received BDPU message
in the message age of the BDPU it transmitted. Also, the message age of the
message transmitted BDPU could be less than that of the received BDPU,
which contravenes IEEE 802.3d. This issue has been resolved.
PCR: 01219
Module: VLAN,SWI
Reception of incorrectly tagged packets was causing corruption of the ARL
table, eventually causing the switch to lock up. This issue has been resolved.
Tagged packets with invalid VLAN identifiers are now discarded. The
INFILTERING parameter of the SET SWITCH PORT command now
defaults to ON.
PCR: 01221
Module: SWI
Flow control performance has been improved.
PCR: 01225
Module: IPSEC
The IPsec SA ID now wraps correctly at the 16 bit (ID = 65535) boundary.
The ID is also checked to verify that it is free before it is used.
Patch Release Note
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Patch 86222-25 for Software Release 2.2.2
C613-10319-00 REV X
Advertisement
