Download Print this page

Allied Telesis 86222-25 Release Note page 29

Patch for rapier switches and ar800 series modular switching routers

Advertisement

Patch 86222-25 For Rapier Switches and AR800 Series Modular Switching Routers
Patch 86222-25 for Software Release 2.2.2
C613-10319-00 REV X
PCR: 01168
Module: HTTP
A watchdog timout occurred when the router received an HTTP message
with an over-length header. Normal HTTP requests would also occasionally
cause watchdog timeouts. These issues have been resolved.
PCR: 01182
Module: OSPF
The OSPF route filter was not filtering out external routes. This issue has
been resolved.
PCR: 01193
Module: IPG
MD5 Authentication now works correctly with RIP packets.
PCR: 01194
Module: L2TP, IPG
The SET IP LOCAL command caused a fatal error if the router was
configured with a default route over an L2TP tunnel, because there was no
valid route to the remote IP address of the tunnel. This issue has been
resolved.
PCR: 01197
Module: Q931
Debug messages are no longer generated when a Q.931 Advise of Charge
Notification message is received.
PCR: 01198
Module: TCP
TCP sessions would get stuck in the FINWAIT2 state if the remote host did
not send a FIN message when required. The router now starts a timer when
a TCP session enters the FINWAIT2 state and will automatically close the
session if the timer expires.
PCR: 01199
Module: IPG
The SET IP FILTER command was not correctly handling the ICMPTYPE
and ICMPCODE parameters. This issue has been resolved.
PCR: 01202
Module: DHCP
The router will now accept DHCP messages that are greater than or equal
to 576 bytes in size, and reject any message smaller than 576 bytes. This
operation conforms to RFC 1541.
PCR: 01203
Module: ISAKMP
ISAKMP quick mode exchanges are now committed if any traffic is received
over the newly generated SA. This improves stability in very lossy networks
where the commit message may get lost.
PCR: 01204
Module: ISAKMP
ISAKMP debugging caused a fatal error when the debugging mode was set
to ALL and PFS was enabled. This issue has been resolved.
PCR: 01205
Module: PPP
PPPoE interfaces with IDLE set to ON would not retry active discovery
when more data was received if active discovery had previously failed. This
issue has been resolved.
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
29

Advertisement

loading