Direct Transmission; Cancelling Direct Transmission - Kyocera FS-C2626MFP Operation Manual

Sending Faxes > Direct Transmission

Direct Transmission

Scans all originals into memory, then dials and sends. Scanning of the originals starts after the connection is made with
the receiving system, allowing you to verify that each page of the fax has been properly sent.
1
2

Cancelling Direct Transmission

During direct transmission, to cancel communication during transmission, press the Stop key on the operation panel or
[Cancel] on the touch panel. The originals that have been scanned are ejected, and the screen returns to the send
default screen. When originals remain in the document processor, take them out.
Setting for Direct
transmission
On
Off
NOTE
In direct transmission, you can designate only one destination for one transmission.
Display the screen.
Ready to send.
FAX
On Hook Chain Direct
Recall
1
Address Book Ext Address Book
Functions
Configure the function.
Ready to send.
FAX Direct Transmission
Off On
Cancel
NOTE
In the basic screen for sending, press
[Direct]. This selects the direct transmission
method and the keys on the touch panel are
highlighted.
Starts direct transmission.
Dials the receiving system, and after the communication has started,
originals are scanned.
Starts memory transmission.
After originals are scanned into memory, the communication starts.
10:10
Dest. :
Check
Add Dest.
2
One Touch Key
Favorites
10:10
OK
Ready to send.
FAX
4-14
Description
Ready to send.
Functions
Job Finish Notice
FAX Delayed Transmission
FAX Direct Transmission
FAX Polling RX
Close
Use [ ] or [ ] to scroll up and down.
On Hook Chain Direct
Recall
Address Book Ext Address Book One Touch Key
Functions
10:10
Off
Off
3/3
Off
Off
Add/Edit
Shortcut
10:10
Dest. :
Check
Add Dest.
Favorites