Table of Contents
Advertisement
www.solutechnic.com
2. Setting for media position detection
This procedure is not required when media position detection is not changed.
When paper remains in the printer, media position detection cannot be set.
Be sure to remove the paper before turning on the printer.
1
Turn the power on.
2
Remove the paper in the printer.
3
Display the printer driver window. (See
page 152
4
Change [Media position detection] on [Maintenance And Utilities]
tab of the printer driver depending on the paper to use.
Receipt/Full-page Label/Transparent Full-page Label
Black Mark Die-cut Label
Black Mark Receipt
Die-cut Label/Black Mark Die-cut Label
/Transparent Die-cut Label
5
Turn the power off.
The changed setting of the media position detection is saved in the NV memory of the
printer when the printer is turned off. Be sure to turn off the printer to enable the setting.
SOLUTECHNIC PARIS-NORD SARL- 52 rue d'Emerainville - Bât Le Croissy A -Marne la Vallée - 77183 CROISSY BEAUBOURG
Tél 01.64.66.80.40 - Fax : 01.64.66.82.18 - mailto : info@solutechnic.com - http://www.solutechnic.com
for how to display the driver window.)
Roll paper type
How to Use the Printer Driver on
Media position detection setting
Not applied
Detects black marks of die-cut label
Detects black marks of receipt
Detects the gap between labels
Chapter 2 Setup
2
79
Advertisement
Table of Contents
