Denon AVR 4308CI - AV Network Receiver Manual page 17

COMMAND PARAMETER
Z3 PHONO
|
IPOD
SOURCE
UP
DOWN
**
ON
OFF
?
Z3MU ON
OFF
?
Z3CS ST
MONO
?
Z3CV FL UP
FL DOWN
FL **
FR UP
FR DOWN
FR **
?
Z3HPF ON
OFF
?
Z3 COMMAND : "*" parameter uses two ASCII characters. (see page4 J) section)
function
MULTI ZONE-3 mode set , and select source at AVR-4308
---The name of PARAMETER is
the same as that of the time of SI COMMAND.
MULTI ZONE-3 mode cancel
MULTI ZONE-3 VOLUME UP/DOWN , direct change to **dB
**:10 to 99 by ASCII , 80=0dB, 99=---(MIN)
MULTI ZONE-3 ON/OFF change at AVR-4308
Return Z3 Status
ZONE3 OUTPUT MUTE ON/OFF change
Return Z3MU Status
ZONE3 Channel setting
Return Z3CS Status
ZONE3 CHANNEL VOLUME UP/DOWN , direct change to **dB
---FRONT Lch
**:38 to 62 by ASCII , 50=0dB
ZONE3 CHANNEL VOLUME UP/DOWN , direct change to **dB
---FRONT Rch
**:38 to 62 by ASCII , 50=0dB
Return Z2CV Status
ZONE3 HPF ON/OFF
Return Z3HPF Status
- 17 -
example
Z3PHONO<CR>
|
Z3IPOD<CR>
Z3SOURCE<CR>
Z3UP<CR>
Z3DOWN<CR>
Z380<CR>
Z3ON<CR>
Z3OFF<CR>
Z2?<CR>
Z3MUON<CR>
Z3MUOFF<CR>
Z3MU?<CR>
Z3CSST
Z3CSMONO
Z3CS?
Z3CVFL UP<CR>
Z3CVFL DOWN<CR>
Z3CVFL 50<CR>
Z3CVFR UP<CR>
Z3CVFR DOWN<CR>
Z3CVFR 50<CR>
Z3CV?<CR>
Z3HPFON<CR>
Z3HPFOFF<CR>
Z3HPF?<CR>