Chapter 5 Reference; Attaching An Arm (Option) - Eizo FlexScan S2111W User Manual

Chapter 5 Reference

5-1 Attaching an Arm (Option)

The stand can be removed and replaced with an arm (or another stand) to be
attached to the monitor. Use an arm or stand of EIZO option.
[Attaching]
1
Lay the LCD monitor on a soft cloth spread over on a stable
surface with the panel surface facing down.
2
Remove the stand. (Prepare a screwdriver.)
Unscrew the four screws securing the unit and the stand with the
screwdriver.
3
Attach the monitor to the arm or stand.
Secure the monitor to the arm or stand using the screws specifi ed in the
user's manual of the arm or stand.
• Clearance between the screw holes when attach an arm or stand:
In case of 100mm × 100mm
• Clearance between the screw holes when attach an arm or stand:
In case of 200mm × 100mm (Only for S2411W)
28
Chapter 5 Reference
Arm
Arm
Attention
• When attaching an arm or stand,
follow the instructions of their user's
manual.
• When using another manufacturer's
arm or stand, confi rm the following in
advance and select one conforming to
the VESA standard. Use M4 × 12 mm
screws supplied with this monitor.
– Clearance between the screw holes:
100 mm × 100 mm
200 mm × 100 mm (Only for
S2411W)
– Thickness of plate: 2.6 mm
– Strong enough to support weight of
the monitor unit (except the stand)
and attachments such as cables.
• Attach an arm or stand to meet the
following tilt angles of the monitor.
– Up 60 degrees, down 45 degrees
(Horizontal display. Or, vertical
display, 90 degrees clockwise in case
of S2111W)
• Connect the cables after attaching an
arm.