Table of Contents
Advertisement
6.
ATTACHING AN ARM
The stand can be removed and replaced with an arm (or another stand) to be attached
to the monitor. Use an arm or stand of EIZO option.
NOTE
When attaching an arm or stand, follow the instructions of their user's manual.
When using another manufacturer's arm or stand, confirm the following in
advance and select one conforming to the VESA standard.
Use M4 ~ 15 mm screws fixing the unit and stand.
– Clearance between the screw holes: 100 mm ~ 100 mm
– Thickness of plate: 2.6 mm
– Strong enough to support weight of the monitor unit (except the stand) and
attachments such as cables
Attach an arm or stand to meet the following tilt angles of the monitor.
– Up 45 degrees, down 45 degrees
– Up 45 degrees, down 45 degrees (vertical display, 90 degrees clockwise)
Connect the cables after attaching an arm.
Setup Procedure
1.
Hold the center of the stand mounting cover and slide them
rightward or leftward to remove the mounting cover.
Stand mounting cover
6. ATTACHING AN ARM
English
39
Advertisement
Table of Contents
