Table of Contents
Advertisement
English
5.
Press the power button while pressing the Input Signal Selection
button.
The Input Selection menu is appeared on the screen.
Input Signal
Selection Button
6.
Change the input selection setting of the connector in the Input
Selection menu to "ADC".
Press Enter button to complete the setting and the menu closes.
7.
Switch on the PC's power.
The monitor's power indicator will light up (blue).
If an image does not appear, refer to the "7. TROUBLESHOOTING" (p. 41)
for additional advice.
Whenever finishing your operation, turn off the PC and the monitor.
NOTE
When changing the signal connector except ADC, open the Input Selection menu
again and change the setting to "Standard".
To reset the setting in the <Others> menu through ScreenManager, the settings
of Input Selection will revert to the default setting.
When turning on the monitor, the kind of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
Adjust brightness of the screen depending on the brightness of your
environment.
Be sure to take adequate rests. A 10-minute rest period each hour is suggested.
18
2. CABLE CONNECTION
SIGNAL
MODE
AUTO
ENTER
1 - 2
Mode Button Enter Button
Power Button Power Indicator
Control Buttons
(Left, Bottom, Up, Right)
Advertisement
Table of Contents
