Canon MX870 Series User Manual page 804

5.
button to select Yes, then press the OK button.
Use the
The Caller history list is printed.
TX Report
This machine can print a TX (transmission) report after sending a document, confirming whether
the transmission has been completed successfully. At the time of purchase, TX reports are set to
be printed only when a transmission error occurred. You can set the machine to print a report each
time it sends a document, or disable printing of the report.
Note
For details on the TX report settings, see
For the errors that occur when you send a fax, see
Errors when you send a fax
If an error occurs when you send a fax, the error number is printed in the TX report (there are some
errors for which the cause is also printed).
The causes corresponding to the error numbers are as follows.
No.
#001 Document is jammed in
the ADF.
#003 Document is too long.
No answer.
#005
#012 Try again.
#017 No tone is detected.
Line was busy.
#018
Try again.
#022
#059 Transmission has been
canceled due to a fax
information mismatch.
TX Report .
Errors when you send a fax
Cause
The document is jammed in the ADF.
Remove the document page jammed in the
ADF. When the error is cleared, redo the
operation. See
You attempted to send a document longer than
15.75 inches / 400 mm.
You cannot send a document longer than
15.75 inches / 400 mm from the ADF.
#003 is also printed if it takes time to send a
page. Divide the document or set the image
quality (Fax resolution) to a lower setting, then
resend it.
The recipient's fax machine does not respond.
Contact the recipient and have the recipient
check that the telephone line is connected
correctly.
There is no paper in the recipient's fax
machine.
Contact the recipient and have the recipient
load paper.
The machine could not detect the dial tone.
Dial tone detect in Transmission settings is set
to ON. Set it to OFF, then send the fax.
The fax/telephone number you dialed is busy.
Try dialing again after waiting for a moment.
The fax/telephone number registered to the
speed dial is incorrect.
Check the recipient's fax/telephone number,
correct the fax/telephone number registered to
the speed dial code, then send the document
again.
Transmission has been canceled because the
machine could not detect the recipient's fax
machine information or the information did not
match the dialed number. This error number is
displayed when Check RX fax information is
set to ON. For details, see
.
Action
Document Jams in the ADF .
Sending Faxes after