HP 4510s - ProBook - Celeron 1.8 GHz Maintenance And Service Manual page 98

2. Lift the display assembly (2) straight up and remove it.
3. If it is necessary to replace the display bezel, display enclosure, or display hinges, remove the eight
rubber screw covers (1) and the eight Phillips PM2.0×6.0 screws (2) that secure the display bezel
to the display assembly. The rubber screw covers are available in the Rubber Kit, spare part number
535793-001.
4. Remove the bezel:
a.
b.
c.
d.
e.
f.
86 Chapter 4 Removal and replacement procedures
Flex the top of the bezel until it disengages from the display enclosure (1).
Flex the inside bottom of the bezel until it disengages from the display enclosure (2).
Flex the outside bottom of the bezel until it disengages from the display enclosure (3).
Lift the bottom corners of the bezel until it disengages (4).
Lift the bezel at the seam in the hinges until it disengages (5).
Remove the bezel from the display enclosure.