Canon Color imageCLASS MF8170c Facsimile Manual page 79

Q Is there <PREPARE NEW* CART> or <REPLACE* CARTRIDGE> message in
the LCD?
A Replace the toner cartridge.
* Indicates either "C", "M", "Y", or "K".
Q Is the machine in the toner saver mode?
A Set <B & W TONER SAVER> to <OFF> in <COMMON SETTINGS> of the
Menu. (See Chapter 10, "Machine Settings," in the Basic Guide.)
Faxes do not print.
Q Is the cartridge installed properly?
A Make sure the cartridge is installed properly. For more information, see Chapter
8, "Maintenance," in the Basic Guide.
Q Is the sealing tape removed from the cartridge?
A Remove the sealing tape from the cartridge. (See "Install the toner cartridges,"
in the Set-Up Instructions for the Machine.)
Q Is any toner left in the cartridge?
A Replace the cartridge with a new one. For more information, see Chapter 8,
"Maintenance," in the Basic Guide.
A Select <KEEP PRINTING> in <PREPARE NEW* CART> in <RX SETTINGS> in
<FAX SETTINGS> of the Menu. With this setting, the machine will not store
documents in the memory even if the toner has run out. (See <8. TONER
SUPPLY LOW> of "Menu Descriptions," on p. 8-6.)
* Indicates either "C", "M", "Y", or "K".
Q Is the correct paper loaded in the cassette?
A Make sure paper is loaded in the cassette. For more information, see Chapter 2,
"Paper Handling," in the Basic Guide.
A Load the correct paper size or change <PAPER SIZE> in <PAPER SETTINGS>
of the Menu. For more information, see the following:
Chapter 2, "Paper Handling," in the Basic Guide
Chapter 5, "Copying," in the Basic Guide
Faxing Problems 7-9
7