Settings; Water Hardness - Bosch TES50129RW Operating Instructions Manual

en
Information: Rinsing the fi lter simultane-
ously activates the setting for the change
fi lter display (= LED
The fi lter is no longer effective when the
change fi lter display appears, or at the
latest after two months. It needs to be re-
placed for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance). Replacement fi lters
can be obtained from retailers (TCZ7003) or
from customer service (467873). If no new
fi lter is inserted, change the setting for the
fi lter (see "Water hardness").
Information: You can use the fi lter indicator
to mark the month in which you inserted the
fi lter. You can also mark the month in which
you will need to replace the fi lter next (at
the latest after two months).
Information: If the appliance has not been
used for a prolonged period (for example,
when you are on vacation), the existing fi lter
should be rinsed before the appliance is
used again. To do so, dispense a cup of hot
water and pour it away.
TES501_Heft1_RW.indb 11
D
fl ashes).

Settings

You can customize the settings on the
appliance.
You can make the following adjustments:

Water hardness

The water hardness setting can be adjusted
on this appliance. It is important to set the
water hardness correctly so that the ap-
pliance can accurately indicate when it is
time to run the descale process. The factory
setting for the water hardness is 4. You can
establish the water hardness either by us-
ing the test strip provided or by asking your
local water provider.
Dip the test strip in the water briefl y, shake
it gently and check the result after one
minute.
Level Water hardness
German (°dH)
1 1-7
2 8-14
3 15-21
4 22-30
If you wish to change the default degree of
water hardness, or if you have inserted a
water fi lter, proceed as follows:
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
(12) simultaneously for at least 5 sec-
onds. The set water hardness is indi-
cated by the number of LEDs that now
light up.
3. Now press the start button (10) repeat-
edly until the required water hardness
is indicated, e. g., for water hardness 3,
D E F
LEDs , and
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the se-
lected water hardness has been saved
successfully.
11
French (°fH)
1-13
14-25
26-38
39-54
B A
(11) and
will light up.
TES501.. 08/2011
14.09.2011 16:10:24