Home Connect Settings; Remote Diagnostics; Data Protection - Bosch CTL7 Series Information For Use

en Home Connect
Open the Home Connect app and
1.
scan the following QR code.
Overview of the Home Connect settings
Here you can find an overview of the "Home Connect" settings and network set-
tings.
Basic setting
Home Connect
assistant
WiFi
Remote start
Software update
Note: When "WiFi" and remote start
are switched on,
display.
13.4 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
56
Selection
Start
Disconnect
On
Off
On
Off
-
appears on the
Follow the instructions in the
2.
Home Connect app.
13.3 Home Connect settings
Adapt Home Connect to your needs.
You can find the Home Connect set-
tings in the basic settings for your ap-
pliance. Which settings the display
shows will depend on whether
Home Connect has been set up and
whether the appliance is connected
to your home network.
Description
Add mobile device.
Disconnect appliance from network.
Switch off the wireless module during
long absences or to save energy.
Note: In networked standby mode
your appliance requires max. 2 W.
Switch remote start on the appliance
on and off.
Note: With the "Home Connect" app
only switch-off is possible.
Note: This setting is only available
with a software update.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com.
13.5 Data protection
Please see the information on data
protection.