Xante Accel-a-Writer 8200 Manual page 37

1. Open any DOS editor, such as Edlin or DOS Edit (see your
DOS or the editor documentation for details).
2. Create a new file by typing the following:
serverdict begin 0 exitserver
statusdict begin
(%disk1%) 0 1 devformat
end
^D
Note: If you are initializing a disk other than disk number
one, be sure to substitute the 1 in (%disk1%) with the
SCSI ID number of the disk you want to initialize.
3. Save the file as INITDSK.PS.
4. Send the INITDSK.PS file to your printer by typing either
COPY INITDSK.PS LPT1
to download to the printer over the parallel interface, or by
typing
COPY INITDSK.PS COM1
to download to the printer over the serial interface.
Note: Turn on the hard disk before turning the printer on whenever
you start your system. This ensures that the printer
recognizes the hard disk. If the start-up page is enabled, the
last line indicates if the hard disk is connected by listing the
disk number and size.
__________________________________________ Installation 2-37