Table of Contents
Advertisement
steps to clean the projection lens:
Follow these
1. Apply a non-abrasive camera lens cleaner to a soft, dry cleaning cloth.
cleaner.
Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
2. Lightly wipe the cleaning cloth over the lens.
3. When you don't use the projector, replace the lens cover.
Before calling your dealer or service station for assistance, check the matters below once again.
1. Make sure you have connected the projector to your equipment as described in section "CONNECTING THE
PROJECTOR" on pages 14- 21.
2. Check cable connections. Verify that all computer, video and power cords are properly connected.
3. Verify that
power
is switched
4. If the projector still does not display an image, re-start the computer.
5. If the image still does not display, unplug the projector from the computer and check the computer
monitor's display. The
reconnect the projector, remember to turn the computer and monitor off before you power up the projector. Power
the equipment back up in order of:
Projector and computer)
6. If the problem still exists, check the following chart.
Problem:
No power
Image is out of focus
- - -
on.
-
problem may be with your graphics controller rather than with the projector. (When you
• Plug the projector into an AC outlet.
•Turn the MAIN ON/OFF switch to ON.
•Press the POWER ON/OFF switch to ON.
•Be
sure the READY INDICATOR light is ON.
•Wait 90 seconds after the projector is turned OFF before turning the projector
back on.
NOTE: After pressing the POWER ON/OFF button to OFF. The projector functions
as indicated.
1.The LAMP POWER indicator will light and the READY indicator will turn-off.
2.After 90 seconds, the READY indicator will light green again and the projector may
be turned on by pressing the POWER ON/OFF button.
•Check temperature warning indicator. If the indicator
cannot be turned on.
(See "BASIC OPERATION" section on page 32).
•Check the projection lamp.
•Replace the lamp cover. (Check the interlock switch inside of the lamp cover.)
~ Adjust the focus.
• Make sure the projection screen is at least 4.9' (1.5 m) from the projector.
• Check the projection lens to see if
NOTE:: Moving the projector from a cool temperature location to a warm
temperature location may result
such an event, leave the projector OFF
disappears
.
Avoid using an excessive amount of
-
Try these Solutions:
-
it needs cleaning.
in moisture condensation on the lens. In
and wait until condensation
flashes red, the projector
-
Advertisement
Table of Contents
