Use Of Telnet - Sanyo Network Board MD13NET Owner's Manual

Use of Serial Port

Use of Telnet

You can control the equipment connected to the serial port on the network board and
control projector itself by using the telnet application*
The following is a control example of external equipment. The telnet application is
required to use commands*
Preparation
1
Turn the projector off with the mains switch and connect an external equipment to
the serial port with an RS-232C serial cable.
2
Turn the projector and external equipment on.
3
Display the setting page by clicking on the Serial Port linked text on the main menu
with the web browser. ( refer to page 62).
4
Change the serial port setting to be the same communication condition as the con-
nected external equipment and then press the Set button.
The following example setting is for our projector
communication condition. When controlling our pro-
jector set as follows
Control
(For example, in case of using the Telnet application in the Windows 98.)
1
Select the Run... submenu from the Start menu on the computer. Type "telnet" onto
the Open text area on the displayed window and press the OK button.
2
Launch the telnet application and the following window will be displayed. Select
the Remote System from the Connect pulldown menu.
*1 For further instructions about the telnet application, please see the on-line guide on your
computer. Macintosh does not provide the telnet application.
*2 The commands are defined by each product independently, so please consult the manufac-
turer or sales dealer for further information of the commands.
66
which control the external equipment.
2
:
1 installed on your computer.
Baud rate ..........19200
Parity ................NONE
Stop ..................1
Flow Control ......NONE
Data ..................8
Serial Control ....External
Port ..................23