Sanyo Network Board MD13NET Owner's Manual page 19

2
Configure the network of the projector by using the web browser.
1
. Enter the IP address of the projector as the URL. The login page will be dis-
played and login. For further information, please see chapter "2: Basic Setting
and Operation" on page 25.
2
. Configure the network through the setting page on the browser. For further
information, please see chapter "Network Configuration" on page 31.
Completing of installation
Now the installation is completed. The IP address of this projector has been set to
"192.168.1.201". You must reset the network configuration of the computer to the
original and restart the computer.
Next, please see chapter "Basic Setting and Operation" on page 25. It describes how
to operate and set up the projector .
If you use a cable to connect the projector and computer directly, without using a hub, you
must use a UTP cross cable. In this case, you cannot access the login page if the setting of
web browser is set to "Use proxy server". It must be changed to the "Not use proxy serv-
er". For further information, please see the "Web browser setting" on page 72.
When you set up the network of projector which has a default setting by using the computer,
it must be carried out in the network which does not provide any gateways (routers). If it has
the gateways (routers), you must carry out the configuration by using the projector's menu.
Network configuration
Network Board
OWNER'S MANUAL
19