Macintosh - Sanyo Network Board MD13NET Owner's Manual

Macintosh

This example explains how to set the following network address.
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Gateway Address : 192.168.100.1
1
Select TCP/IP*
[Apple] - [Control Panel] menu.
2
Select Ethernet from the "Connect
via" pull-down menu and Manually
from the "Configure" pull-down
menu of the TCP/IP Control Panel.
3
Enter the IP Address*
Mask.
4
Enter the Router Address.
This setting is not needed if the net-
work does not provide the gateway
(router).
5
Close the setting window and save
the setting.
*1 Select the "TCP/IP" item of the LAN card you use. If the "TCP/IP" item is not listed in the
column, you need to install the TCP/IP protocol. For further information refer to the user's
manual of your computer.
*2 If the network already has the TCP/IP protocol set, enter with the same IP network number
for the IP address and Subnet mask.
menu from the
1
and Subnet
2
Configure the network of computer
Network Board
OWNER'S MANUAL
23